APRS Track Direct

My position About ☰

reset

JA2YQQ-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object JA2YQQ-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786751780	120	103	255	76	78
1786750877	120	101	255	77	79
1786749976	120	100	255	78	80
1786749075	120	99	255	79	79
1786748174	120	98	255	79	81
1786747273	120	98	255	79	81
1786746372	120	98	255	79	80
1786745471	120	97	255	80	81
1786744570	120	97	255	80	82
1786743669	120	96	255	80	83
1786742768	120	96	255	81	83
1786741867	120	96	255	81	83
1786740966	120	96	255	81	82
1786740064	120	96	255	81	83
1786739163	120	96	255	81	83
1786738262	120	96	255	81	83
1786737361	120	96	255	81	81
1786736460	120	96	255	81	83
1786735559	120	96	255	81	83
1786734658	120	96	255	81	83
1786733757	120	96	255	81	83
1786732856	120	96	255	81	82
1786731955	120	96	255	81	83
1786731054	120	96	255	81	83
1786730153	120	96	255	81	82

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)