APRS Track Direct

My position About ☰

reset

EA5DHO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA5DHO-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1836274365	18 Count	663 Count	0 Count
1836274212	17 Count	625 Count	0 Count
1774122401	19 Count	645 Count	0 Count
1774121318	18 Count	621 Count	0 Count
1774120235	17 Count	597 Count	0 Count
1774119153	16 Count	567 Count	0 Count
1774118068	15 Count	539 Count	0 Count
1774116985	14 Count	514 Count	0 Count
1774115902	13 Count	487 Count	0 Count
1774114821	12 Count	456 Count	0 Count
1774113736	11 Count	426 Count	0 Count
1774112653	10 Count	399 Count	0 Count
1774111569	9 Count	373 Count	0 Count
1774110486	8 Count	339 Count	0 Count
1774109403	7 Count	308 Count	0 Count
1774108319	6 Count	279 Count	0 Count
1774107236	5 Count	244 Count	0 Count
1774106153	4 Count	218 Count	0 Count
1774105071	3 Count	190 Count	0 Count
1774104047	2 Count	145 Count	0 Count
1774102964	1 Count	87 Count	0 Count
1774101880	0 Count	61 Count	0 Count
1774100797	71 Count	1052 Count	23 Count
1774099714	70 Count	998 Count	23 Count
1774098631	69 Count	955 Count	23 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)