APRS Track Direct

My position About ☰

reset

SQ9MJ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9MJ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790636744	127 Count	613 Count	13 Count
1790635843	126 Count	597 Count	13 Count
1790634942	125 Count	578 Count	13 Count
1790633140	122 Count	550 Count	13 Count
1790632239	121 Count	539 Count	13 Count
1790631338	120 Count	526 Count	13 Count
1790630437	118 Count	514 Count	13 Count
1790629536	117 Count	502 Count	13 Count
1790628635	116 Count	489 Count	13 Count
1790627756	115 Count	477 Count	13 Count
1790626855	113 Count	468 Count	13 Count
1790625954	112 Count	455 Count	13 Count
1790625053	111 Count	445 Count	13 Count
1790624152	110 Count	429 Count	13 Count
1790623251	108 Count	419 Count	13 Count
1790622349	107 Count	406 Count	13 Count
1790621448	106 Count	394 Count	13 Count
1790620547	105 Count	382 Count	13 Count
1790619646	103 Count	372 Count	13 Count
1790618746	102 Count	361 Count	13 Count
1790617845	92 Count	335 Count	4 Count
1790616944	87 Count	299 Count	0 Count
1790616043	85 Count	284 Count	0 Count
1790615142	84 Count	271 Count	0 Count
1790614241	83 Count	263 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)