APRS Track Direct

My position About ☰

reset

DL4MDW-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL4MDW-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1750112876	4088	2560	119	991	1699
1750112636	4024	1585	120	997	1699
1750112456	4088	2421	118	993	1701
1750112396	4088	2592	121	995	1701
1750112336	4032	1622	121	997	1698
1750112276	4079	1739	120	998	1698
1750112216	4032	1636	121	999	1698
1750112156	4088	2593	121	998	1699
1750112096	4088	2590	122	998	1698
1750112044	4032	1668	118	999	1699
1750111976	4040	1615	120	998	1697
1750111916	4088	2514	119	997	1700
1750111856	4088	2529	121	998	1701
1750111796	4088	2458	121	1004	1698
1750111736	4027	1709	122	1005	1698
1750111676	4032	1708	120	1001	1700
1750111616	4035	1592	121	1002	1699
1750111556	4032	1712	119	1003	1699
1750111496	4088	2640	122	1004	1699
1750111436	4041	1635	119	1005	1699
1750111376	4040	1707	120	1007	1697
1750111316	4032	1691	121	1011	1696
1750111256	4088	2711	122	1014	1697
1750111196	4032	1738	121	1016	1698
1750111136	4032	1752	122	1019	1693

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)