APRS Track Direct

My position About ☰

reset

NR0Q-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object NR0Q-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1750195415	139	89	999	239	128
1750195231	142	88	999	243	131
1750195049	141	87	999	245	135
1750194865	141	85	999	249	140
1750194684	141	83	999	254	146
1750194501	141	82	999	260	152
1750194320	141	79	999	267	159
1750194139	141	76	999	275	171
1750193776	141	58	999	325	229
1750179905	142	65	999	296	202
1750179726	142	62	999	305	213
1750178419	141	53	999	328	243
1750178230	124	40	999	287	186
1750164697	141	70	999	282	184
1750164335	122	61	999	289	188
1750163990	139	70	999	285	188
1750163809	142	68	999	285	188
1750163442	142	67	999	291	195
1750162898	143	61	999	306	215
1750162353	125	40	999	287	185

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)