APRS Track Direct

My position About ☰

reset

MW0KEC-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MW0KEC-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1770150387	312 Count	574 Count	191 Count
1770148584	306 Count	559 Count	186 Count
1770146781	301 Count	542 Count	182 Count
1770144978	297 Count	534 Count	179 Count
1770143175	291 Count	517 Count	174 Count
1770141372	285 Count	500 Count	169 Count
1770139569	273 Count	477 Count	158 Count
1770137766	269 Count	471 Count	155 Count
1770135963	263 Count	458 Count	150 Count
1770134160	258 Count	440 Count	146 Count
1770132357	253 Count	427 Count	142 Count
1770130589	248 Count	415 Count	138 Count
1770128786	245 Count	403 Count	136 Count
1770126983	239 Count	387 Count	131 Count
1770125180	234 Count	374 Count	127 Count
1770123377	231 Count	364 Count	125 Count
1770121574	224 Count	347 Count	119 Count
1770119771	220 Count	339 Count	116 Count
1770117968	214 Count	325 Count	111 Count
1770116165	210 Count	315 Count	108 Count
1770114362	204 Count	302 Count	103 Count
1770112559	199 Count	288 Count	99 Count
1770110756	194 Count	273 Count	95 Count
1770108989	189 Count	258 Count	91 Count
1770107186	181 Count	240 Count	87 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)