APRS Track Direct

My position About ☰

reset

OK1FWG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1FWG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1836274286	147 Count	59 Count	58 Count
1766208993	34 Count	16 Count	16 Count
1766207190	32 Count	15 Count	15 Count
1766205387	28 Count	14 Count	14 Count
1766203584	25 Count	12 Count	12 Count
1766201781	23 Count	12 Count	12 Count
1766199978	21 Count	11 Count	11 Count
1766198175	16 Count	9 Count	9 Count
1766196372	13 Count	7 Count	7 Count
1766194568	12 Count	7 Count	7 Count
1766192765	9 Count	5 Count	5 Count
1766190962	5 Count	3 Count	3 Count
1766189159	3 Count	2 Count	2 Count
1766187355	1 Count	1 Count	1 Count
1766185552	1001 Count	505 Count	498 Count
1766183749	995 Count	503 Count	496 Count
1766181946	992 Count	501 Count	494 Count
1766180143	990 Count	500 Count	493 Count
1766178340	989 Count	500 Count	493 Count
1766176537	985 Count	499 Count	492 Count
1766174734	983 Count	498 Count	491 Count
1766172930	982 Count	498 Count	491 Count
1766171127	980 Count	497 Count	490 Count
1766169324	977 Count	497 Count	490 Count
1766167521	975 Count	496 Count	489 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)