APRS Track Direct

My position About ☰

reset

HB9IMG Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HB9IMG. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790653597	341 Count	229 Count	229 Count
1790651794	338 Count	227 Count	227 Count
1790649990	335 Count	225 Count	225 Count
1790646421	324 Count	220 Count	220 Count
1790644618	321 Count	218 Count	218 Count
1790642814	318 Count	216 Count	216 Count
1790639207	310 Count	210 Count	210 Count
1790637404	306 Count	207 Count	207 Count
1790635601	304 Count	206 Count	206 Count
1790633797	300 Count	203 Count	203 Count
1790631994	297 Count	201 Count	201 Count
1790630191	295 Count	200 Count	200 Count
1790626584	292 Count	199 Count	199 Count
1790624818	286 Count	198 Count	198 Count
1790623015	283 Count	196 Count	196 Count
1790621211	281 Count	195 Count	195 Count
1790619408	276 Count	191 Count	191 Count
1790617605	273 Count	189 Count	189 Count
1790615801	268 Count	185 Count	185 Count
1790613998	264 Count	182 Count	182 Count
1790612194	262 Count	181 Count	181 Count
1790610391	261 Count	181 Count	181 Count
1790606784	247 Count	169 Count	169 Count
1790604981	224 Count	147 Count	147 Count
1790603215	212 Count	140 Count	140 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)