APRS Track Direct

My position About ☰

reset

SP2AJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2AJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786737751	239 Count	357 Count	205 Count
1786736850	231 Count	342 Count	198 Count
1786735949	221 Count	326 Count	189 Count
1786735049	215 Count	314 Count	184 Count
1786734148	205 Count	294 Count	175 Count
1786733264	192 Count	276 Count	163 Count
1786732363	188 Count	269 Count	160 Count
1786731462	184 Count	262 Count	157 Count
1786730561	180 Count	255 Count	154 Count
1786729661	170 Count	243 Count	145 Count
1786728760	159 Count	229 Count	135 Count
1786727859	141 Count	210 Count	118 Count
1786726958	129 Count	197 Count	107 Count
1786726057	125 Count	189 Count	104 Count
1786725157	118 Count	180 Count	98 Count
1786724256	113 Count	172 Count	94 Count
1786723355	110 Count	168 Count	92 Count
1786722454	101 Count	157 Count	84 Count
1786721554	97 Count	151 Count	81 Count
1786720653	93 Count	144 Count	78 Count
1786719752	90 Count	140 Count	76 Count
1786718851	85 Count	132 Count	72 Count
1786717950	82 Count	127 Count	70 Count
1786717050	79 Count	123 Count	68 Count
1786716149	77 Count	119 Count	67 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)