APRS Track Direct

My position About ☰

reset

SP8PB-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8PB-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1768117082	500 Count	713 Count	236 Count
1768116181	497 Count	708 Count	234 Count
1768115281	494 Count	704 Count	232 Count
1768114380	492 Count	702 Count	231 Count
1768113480	490 Count	700 Count	230 Count
1768112579	488 Count	697 Count	229 Count
1768111678	486 Count	695 Count	228 Count
1768110778	484 Count	693 Count	227 Count
1768109877	482 Count	691 Count	226 Count
1768108977	480 Count	688 Count	225 Count
1768108076	478 Count	686 Count	224 Count
1768107175	476 Count	684 Count	223 Count
1768106275	474 Count	681 Count	222 Count
1768105374	472 Count	677 Count	221 Count
1768104473	470 Count	674 Count	220 Count
1768103573	468 Count	672 Count	219 Count
1768102672	466 Count	670 Count	218 Count
1768101772	464 Count	667 Count	217 Count
1768100871	462 Count	665 Count	216 Count
1768099970	460 Count	663 Count	215 Count
1768099070	458 Count	661 Count	214 Count
1768098169	456 Count	658 Count	213 Count
1768097281	450 Count	656 Count	212 Count
1768096381	448 Count	653 Count	211 Count
1768095480	446 Count	650 Count	210 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)