APRS Track Direct

My position About ☰

reset

IT9IRS-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786737064	219 Count	278 Count	55 Count
1786736760	218 Count	277 Count	55 Count
1786736455	216 Count	275 Count	54 Count
1786736151	215 Count	273 Count	54 Count
1786735847	214 Count	271 Count	54 Count
1786735542	212 Count	270 Count	53 Count
1786735238	210 Count	268 Count	52 Count
1786734933	209 Count	267 Count	52 Count
1786734629	207 Count	264 Count	51 Count
1786734325	206 Count	262 Count	51 Count
1786734020	205 Count	258 Count	51 Count
1786733716	203 Count	257 Count	50 Count
1786733412	202 Count	257 Count	50 Count
1786733107	200 Count	253 Count	49 Count
1786732803	199 Count	252 Count	49 Count
1786732499	198 Count	249 Count	49 Count
1786732194	196 Count	247 Count	48 Count
1786731585	192 Count	239 Count	46 Count
1786730977	189 Count	235 Count	45 Count
1786730672	188 Count	234 Count	45 Count
1786730064	185 Count	230 Count	44 Count
1786729877	180 Count	230 Count	44 Count
1786729573	179 Count	227 Count	44 Count
1786729269	178 Count	227 Count	44 Count
1786728964	177 Count	227 Count	44 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)