APRS Track Direct

My position About ☰

reset

E22DXH Telemetry

This is the latest recevied telemetry packets stored in our database for station/object E22DXH. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	RSSI*	Voltage*
1770094793	-51 dBm	0.59 V
1770093571	-50 dBm	0.59 V
1770092349	-50 dBm	0.59 V
1770091127	-50 dBm	0.62 V
1770089905	-50 dBm	0.62 V
1770088683	-50 dBm	0.64 V
1770087461	-50 dBm	0.64 V
1770086239	-51 dBm	0.64 V
1770085017	-50 dBm	0.64 V
1770083794	-51 dBm	0.66 V
1770082572	-51 dBm	0.66 V
1770081350	-50 dBm	0.66 V
1770080128	-51 dBm	0.66 V
1770078906	-51 dBm	0.66 V
1770077684	-51 dBm	0.64 V
1770076462	-51 dBm	0.64 V
1770075240	-51 dBm	0.64 V
1770074018	-51 dBm	0.64 V
1770072796	-51 dBm	0.64 V
1770071574	-51 dBm	0.64 V
1770070352	-51 dBm	0.64 V
1770069130	-51 dBm	0.64 V
1770067908	-51 dBm	0.64 V
1770066686	-51 dBm	0.64 V
1770065464	-50 dBm	0.64 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)