APRS Track Direct

My position About ☰

reset

E22DXH-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object E22DXH-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RSSI*	Voltage*
1778038032	-43 dBm	0.59 V
1778036207	-43 dBm	0.55 V
1778034382	-43 dBm	2.05 V
1778032557	-42 dBm	0.18 V
1778030732	-44 dBm	1.25 V
1778028907	-43 dBm	0.35 V
1778027081	-43 dBm	1.23 V
1778025256	-38 dBm	1.33 V
1778023431	-39 dBm	0.43 V
1778021606	-40 dBm	0.55 V
1778019781	-39 dBm	0.55 V
1778017956	-39 dBm	0.39 V
1778016131	-40 dBm	0.74 V
1778013102	-40 dBm	0.64 V
1778011277	-40 dBm	1.27 V
1778009452	-39 dBm	0.35 V
1778007627	-40 dBm	0.88 V
1778005802	-40 dBm	0.21 V
1778003977	-39 dBm	3.55 V
1778002152	-39 dBm	6.69 V
1778000326	-39 dBm	1.13 V
1777998501	-39 dBm	0.35 V
1777996676	-39 dBm	1.29 V
1777994851	-38 dBm	0.86 V
1777993026	-39 dBm	0.35 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)