APRS Track Direct

My position About ☰

reset

F4GCF-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GCF-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1786729425	563 Count	270 Count
1786728824	551 Count	263 Count
1786728224	544 Count	258 Count
1786727624	536 Count	255 Count
1786727024	524 Count	248 Count
1786726424	514 Count	243 Count
1786725824	502 Count	238 Count
1786725224	491 Count	230 Count
1786724624	484 Count	226 Count
1786724024	474 Count	222 Count
1786723423	469 Count	218 Count
1786722823	455 Count	213 Count
1786722223	444 Count	208 Count
1786721623	432 Count	202 Count
1786721023	423 Count	198 Count
1786720423	413 Count	192 Count
1786719823	408 Count	188 Count
1786719223	400 Count	185 Count
1786718623	391 Count	179 Count
1786718022	387 Count	177 Count
1786717422	381 Count	174 Count
1786716822	372 Count	171 Count
1786716222	364 Count	166 Count
1786715622	351 Count	160 Count
1786715022	343 Count	156 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)