APRS Track Direct

My position About ☰

reset

SR2JP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2JP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1790639881	626 Count	250 Count
1790638200	619 Count	248 Count
1790636519	613 Count	246 Count
1790635089	605 Count	244 Count
1790633409	598 Count	242 Count
1790631728	591 Count	240 Count
1790630047	584 Count	237 Count
1790628366	578 Count	235 Count
1790626686	571 Count	228 Count
1790625005	564 Count	226 Count
1790623324	557 Count	224 Count
1790621643	552 Count	223 Count
1790619962	546 Count	221 Count
1790618281	539 Count	219 Count
1790616601	533 Count	217 Count
1790614920	529 Count	215 Count
1790613487	517 Count	213 Count
1790611806	510 Count	211 Count
1790610126	504 Count	209 Count
1790608445	492 Count	207 Count
1790606764	481 Count	205 Count
1790605083	467 Count	199 Count
1790603403	461 Count	197 Count
1790601722	455 Count	194 Count
1790600041	450 Count	193 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)