APRS Track Direct

My position About ☰

reset

NE9DX-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object NE9DX-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790628542	138	160	255	91	68
1790626739	138	160	255	91	68
1790624937	138	160	255	91	68
1790623135	138	160	255	92	69
1790621333	138	160	255	92	69
1790619524	138	160	255	92	69
1790617723	122	160	255	87	65
1790616242	138	160	255	93	70
1790614440	138	159	255	93	70
1790612646	138	159	255	94	71
1790610833	138	159	255	94	71
1790609031	138	159	255	95	72
1790607228	138	159	255	95	71
1790605426	138	159	255	95	72
1790603623	138	159	255	95	72
1790601819	138	159	255	95	72
1790600006	138	159	255	95	71
1790598199	138	159	255	94	71
1790596391	121	159	255	87	66
1790594911	138	159	255	94	71
1790593105	120	159	255	94	71
1790591302	138	159	255	94	71
1790589500	138	159	255	94	71
1790587697	138	159	255	94	71
1790585895	138	159	255	94	71

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)