APRS Track Direct

My position About ☰

reset

XQ3PCN-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XQ3PCN-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1790648773	19 Count	210 Count
1790647869	18 Count	175 Count
1790646965	17 Count	141 Count
1790646061	7 Count	103 Count
1790645158	6 Count	58 Count
1790644254	2 Count	32 Count
1790643350	81 Count	1016 Count
1790642447	73 Count	983 Count
1790641543	72 Count	952 Count
1790640639	71 Count	918 Count
1790639735	70 Count	884 Count
1790638921	64 Count	861 Count
1790638018	63 Count	827 Count
1790637114	62 Count	794 Count
1790636210	61 Count	760 Count
1790635306	53 Count	734 Count
1790634403	52 Count	694 Count
1790633499	51 Count	652 Count
1790632595	50 Count	624 Count
1790631691	42 Count	590 Count
1790630787	41 Count	549 Count
1790629883	40 Count	519 Count
1790628979	39 Count	469 Count
1790628075	31 Count	423 Count
1790627171	30 Count	392 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)