APRS Track Direct

My position About ☰

reset

N7PDI-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N7PDI-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1782519490	132	77	132	118	104
1782518718	132	77	132	119	105
1782517946	134	78	131	118	105
1782517164	134	77	132	118	104
1782516392	133	77	132	117	105
1782514848	134	77	132	118	105
1782512533	134	76	133	119	106
1782511761	134	75	132	118	105
1782507122	133	75	132	119	106
1782506347	133	74	133	118	106
1782505566	133	74	132	119	106
1782504789	134	74	132	118	106
1782504017	134	73	131	118	106
1782500151	134	72	134	119	107
1782499380	133	71	133	119	106
1782498607	134	71	133	119	107
1782496284	134	71	133	120	108
1782495513	135	70	133	119	107
1782492418	133	69	133	119	108
1782490101	134	68	133	121	108
1782489329	133	68	132	119	107
1782485467	140	68	133	121	108
1782482376	139	68	132	120	108
1782481605	141	68	132	120	109
1782480832	129	68	132	121	109

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)