APRS Track Direct

My position About ☰

reset

PY5LF-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PY5LF-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1774128570	116	61	45	123	19
1774128270	116	69	56	123	30
1774127969	117	72	72	124	42
1774127669	117	128	108	124	78
1774127647	117	129	111	124	80
1774127346	118	145	144	125	113
1774127046	122	150	149	128	119
1774126744	126	155	155	131	124
1774126443	130	167	166	135	135
1774126142	130	175	173	137	136
1774125841	130	176	174	137	137
1774125541	132	179	176	139	139
1774125240	134	180	178	141	140
1774124940	134	183	179	141	141
1774124638	134	185	180	141	141
1774124338	134	184	180	141	141
1774124037	134	184	180	141	141
1774123736	134	187	182	141	141
1774123434	134	188	184	141	141
1774123133	134	191	188	141	141
1774122833	134	189	186	141	141
1774122530	134	190	187	141	141
1774122228	134	190	187	141	141
1774121926	134	191	189	141	141
1774121624	134	191	188	141	141

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)