APRS Track Direct

My position About ☰

reset

KF6VAN-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KF6VAN-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1753616343	136	45	31	23	120
1753614543	136	45	30	23	121
1753612743	136	45	31	23	121
1753610943	136	46	32	23	121
1753609143	136	46	32	23	121
1753607343	135	46	31	22	121
1753605543	136	46	32	23	120
1753603743	135	46	31	22	120
1753601943	135	46	31	23	120
1753600143	136	46	32	23	121
1753598343	136	45	32	23	121
1753596543	136	45	30	23	121
1753594743	136	45	31	23	120
1753592943	136	45	30	23	120
1753589343	136	44	31	23	121
1753587543	136	44	30	23	120
1753585743	135	45	31	23	121
1753583943	136	39	28	22	119
1753582143	135	39	29	22	119
1753580343	136	39	28	22	119
1753578542	136	39	28	22	119
1753576742	136	41	29	22	119
1753574942	135	38	29	21	119
1753573142	136	41	29	23	120
1753571342	135	39	28	21	119

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)