APRS Track Direct

My position About ☰

reset

W8ALC Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W8ALC. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790640603	255	77	53	56	51
1790639400	255	76	53	56	51
1790638199	255	76	52	56	51
1790636996	255	76	52	56	50
1790635793	255	76	52	56	50
1790634591	255	76	52	56	50
1790633390	255	76	52	56	50
1790632188	255	76	52	55	50
1790630985	255	76	52	55	50
1790629781	255	76	52	56	51
1790628576	255	76	52	56	51
1790627375	255	77	53	56	51
1790626173	255	77	53	57	52
1790624972	255	78	54	57	52
1790623771	255	78	54	57	53
1790622568	255	78	54	58	53
1790621367	255	79	55	58	53
1790620161	255	79	55	58	53
1790618954	255	80	56	59	54
1790617753	255	80	56	59	54
1790616552	255	80	56	59	55
1790615350	255	80	57	60	55
1790614149	255	81	57	60	55
1790612948	255	81	57	60	55
1790611747	255	81	58	60	56

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)