APRS Track Direct

My position About ☰

reset

YC3BVG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YC3BVG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1768279433	180	53000	694	257	170
1768278528	180	53000	695	893	167
1768277623	210	54000	696	258	166
1768276719	190	54000	697	263	185
1768275814	220	53000	697	446	172
1768274909	250	53000	699	397	177
1768274004	170	54000	700	515	187
1768273099	180	53000	704	380	209
1768272193	180	54000	726	311	222
1768271288	250	53000	730	309	257
1768270383	290	52000	732	425	337
1768265534	440	51000	736	0	0
1768264907	230	53000	237	279	176
1768264003	160	54000	237	176	157
1768263098	200	54000	238	246	151
1768262193	270	54000	237	843	145
1768261288	260	53000	238	582	141
1768260382	250	54000	240	308	147
1768259477	230	53000	233	322	141
1768258572	240	53000	234	152	162
1768257668	220	54000	234	322	153
1768256763	200	54000	236	201	151
1768255858	210	54000	238	178	151
1768254953	400	53000	237	168	147
1768254047	170	53000	238	161	153

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)