APRS Track Direct

My position About ☰

reset

EA4CPM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4CPM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770118924	122 Count	341 Count	89 Count
1770117121	115 Count	334 Count	83 Count
1770115318	114 Count	334 Count	83 Count
1770113515	113 Count	334 Count	83 Count
1770111711	112 Count	333 Count	83 Count
1770109908	111 Count	333 Count	83 Count
1770108142	110 Count	333 Count	83 Count
1770106339	108 Count	324 Count	82 Count
1770104536	101 Count	307 Count	76 Count
1770102733	95 Count	287 Count	71 Count
1770100929	89 Count	273 Count	66 Count
1770099126	84 Count	259 Count	62 Count
1770097323	77 Count	245 Count	56 Count
1770095520	72 Count	227 Count	52 Count
1770093716	65 Count	211 Count	46 Count
1770091913	61 Count	195 Count	43 Count
1770090110	53 Count	180 Count	36 Count
1770088307	49 Count	162 Count	33 Count
1770086538	44 Count	147 Count	29 Count
1770084735	42 Count	134 Count	28 Count
1770082932	37 Count	122 Count	24 Count
1770081129	34 Count	111 Count	22 Count
1770079325	31 Count	100 Count	20 Count
1770077522	28 Count	91 Count	18 Count
1770075719	25 Count	80 Count	16 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)