APRS Track Direct

My position About ☰

reset

EA4IAX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4IAX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1782507917	479 Count	983 Count
1782504314	474 Count	975 Count
1782500710	469 Count	967 Count
1782497107	465 Count	954 Count
1782493504	460 Count	938 Count
1782489901	455 Count	921 Count
1782486298	450 Count	907 Count
1782482694	445 Count	891 Count
1782479091	440 Count	872 Count
1782475488	435 Count	851 Count
1782471920	429 Count	832 Count
1782468317	424 Count	811 Count
1782464714	419 Count	790 Count
1782461111	414 Count	775 Count
1782457510	408 Count	759 Count
1782453905	404 Count	744 Count
1782450303	399 Count	731 Count
1782446700	394 Count	717 Count
1782443097	389 Count	702 Count
1782439494	384 Count	681 Count
1782435891	380 Count	660 Count
1782432288	375 Count	640 Count
1782428728	370 Count	617 Count
1782425125	365 Count	596 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)