APRS Track Direct

My position About ☰

reset

F4HVV-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4HVV-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1750193053	13177	39	13467	65	26.58
1750193048	13522	38	17967	60	28.93
1750191559	13473	37	19263	55	32.05
1750191555	13413	37	19790	54	34.4
1750191552	13389	38	20153	53	35.08
1750191548	13395	33	20389	50	35.6
1750172270	13528	37	21915	49	31.88
1750172266	13522	82	21861	79	31.38
1750172262	13534	37	21964	48	30.85
1750172258	13595	37	22285	54	27.15
1750172255	13637	38	22115	90	24.85
1750172251	13661	37	22133	98	24.08
1750169451	13679	37	22048	130	22.93
1750169448	13685	37	22024	151	22.08
1750168349	14775	32	21134	300	21.28
1750168345	13976	89	20486	276	19.68
1750153441	13776	36	20165	232	18.6
1750153437	13570	34	17791	192	17.48
1750149661	13504	35	19814	166	15.83
1750147952	13031	38	16386	92	13.88
1750146518	12959	37	16259	81	13.55
1750142488	12868	97	15714	74	13.28
1750142333	12868	38	14297	71	12.95
1750141588	12838	39	14000	67	12.73
1750140701	12807	38	13104	61	12.55

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)