APRS Track Direct

My position About ☰

reset

OR7F-8 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OR7F-8. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*
1754110718	15	1216	3369	57
1754110366	15	1216	3369	57
1754110030	15	1216	3369	57
1754109703	9	1216	3368	57
1754109397	14	1216	3368	57
1754109086	16	1216	3368	57
1754108783	16	1216	3367	57
1754108453	8	1216	3367	57
1754108150	10	1216	3367	57
1754107847	15	1216	3368	57
1754107479	14	1216	3368	57
1754107173	14	1216	3368	57
1754106870	10	1216	3369	57
1754106526	8	1216	3370	57
1754106198	8	1216	3371	57
1754105871	15	1216	3372	57
1754105557	13	1216	3375	57
1754105254	15	1216	3376	57
1754104943	15	1216	3378	57
1754104621	9	1216	3380	57
1754104318	16	1216	3383	57
1754103982	10	1214	3386	57
1754103677	11	1216	3389	57
1754103342	12	1216	3391	57
1754103030	12	1216	3394	57

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)