APRS Track Direct

My position About ☰

reset

PU5SZN-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PU5SZN-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790634484	124	9	9	127	108
1790634183	124	9	9	127	108
1790633883	124	10	10	127	108
1790633582	124	11	11	127	108
1790633282	124	11	11	127	108
1790632981	124	12	12	127	108
1790632681	124	12	12	127	108
1790632380	124	13	13	127	108
1790632080	124	14	13	127	108
1790631779	124	17	17	127	108
1790631478	124	21	21	127	108
1790631178	124	30	29	127	108
1790630877	124	52	52	127	108
1790630594	124	58	57	127	108
1790630276	124	58	58	127	108
1790629976	124	58	58	127	108
1790629676	124	59	58	127	108
1790629375	124	59	58	127	108
1790629074	124	59	59	127	108
1790628516	121	71	70	125	108
1790628464	124	64	64	127	108
1790628164	124	65	64	127	108
1790627863	124	65	64	127	109
1790627562	124	65	64	127	109
1790627261	124	65	64	127	109

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)