APRS Track Direct

My position About ☰

reset

IR3T Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IR3T. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1754228455	139	127	175	140	150
1754213755	139	128	175	140	149
1754189257	139	128	177	141	152
1754188645	139	128	177	141	152
1754188033	139	128	177	141	152
1754186808	139	128	177	141	153
1754175169	139	128	177	142	155
1754173945	139	128	177	142	155
1754173332	139	128	177	142	155
1754172109	139	128	177	142	155
1754171495	139	128	177	142	155
1754170883	139	128	177	142	156
1754170271	139	128	177	142	156
1754169658	139	128	177	142	156
1754169046	139	128	177	142	156
1754168434	139	127	178	142	156
1754167821	139	128	178	142	156
1754165980	139	128	178	142	157
1754164143	139	128	178	142	157
1754163531	139	128	178	142	157
1754161694	139	128	178	142	157
1754159857	139	128	178	142	158
1754159244	139	128	178	142	157
1754158632	139	128	178	142	157
1754158020	139	128	178	142	157

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)