APRS Track Direct

My position About ☰

reset

SP8KZI-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8KZI-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1768076393	182 Count	340 Count	128 Count
1768074593	178 Count	331 Count	125 Count
1768072791	174 Count	320 Count	122 Count
1768070999	165 Count	310 Count	118 Count
1768069198	161 Count	302 Count	115 Count
1768067397	158 Count	295 Count	113 Count
1768065596	154 Count	287 Count	110 Count
1768063796	150 Count	279 Count	107 Count
1768061995	146 Count	271 Count	104 Count
1768060194	141 Count	262 Count	100 Count
1768058394	137 Count	253 Count	97 Count
1768056593	131 Count	242 Count	92 Count
1768054792	127 Count	234 Count	89 Count
1768052991	123 Count	226 Count	86 Count
1768051190	119 Count	216 Count	83 Count
1768049398	110 Count	205 Count	79 Count
1768047597	106 Count	197 Count	76 Count
1768045796	102 Count	188 Count	73 Count
1768043995	97 Count	179 Count	69 Count
1768040394	88 Count	162 Count	62 Count
1768038593	84 Count	154 Count	59 Count
1768036792	80 Count	146 Count	56 Count
1768034992	75 Count	137 Count	52 Count
1768033191	71 Count	129 Count	49 Count
1768031390	66 Count	119 Count	45 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)