APRS Track Direct

My position About ☰

reset

SP3DVO-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3DVO-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1786727610	6 Count	87 Count
1786726708	5 Count	77 Count
1786725808	4 Count	66 Count
1786724907	3 Count	47 Count
1786724006	2 Count	36 Count
1786723105	1 Count	19 Count
1786722204	0 Count	10 Count
1786721304	81 Count	1004 Count
1786720403	80 Count	994 Count
1786719502	79 Count	983 Count
1786718601	78 Count	972 Count
1786717701	77 Count	962 Count
1786716800	76 Count	951 Count
1786715899	75 Count	940 Count
1786714998	74 Count	930 Count
1786714112	73 Count	917 Count
1786713212	72 Count	901 Count
1786712311	71 Count	883 Count
1786711410	70 Count	875 Count
1786710510	69 Count	866 Count
1786709609	68 Count	856 Count
1786708708	67 Count	846 Count
1786707807	66 Count	836 Count
1786706907	65 Count	812 Count
1786706006	64 Count	799 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)