APRS Track Direct

My position About ☰

reset

SP9EPW-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9EPW-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1774515375	168 Count	450 Count	134 Count
1774513574	163 Count	435 Count	130 Count
1774511774	157 Count	410 Count	125 Count
1774509973	151 Count	370 Count	120 Count
1774508172	145 Count	344 Count	115 Count
1774504579	129 Count	307 Count	105 Count
1774502778	123 Count	281 Count	100 Count
1774500977	117 Count	257 Count	95 Count
1774499176	111 Count	237 Count	90 Count
1774497376	105 Count	221 Count	85 Count
1774495575	99 Count	206 Count	80 Count
1774493774	93 Count	195 Count	75 Count
1774491973	87 Count	182 Count	70 Count
1774490172	81 Count	169 Count	65 Count
1774488372	75 Count	156 Count	60 Count
1774486571	69 Count	140 Count	55 Count
1774484770	63 Count	128 Count	50 Count
1774482977	53 Count	112 Count	45 Count
1774481177	47 Count	98 Count	40 Count
1774479376	41 Count	86 Count	35 Count
1774477575	35 Count	73 Count	30 Count
1774475775	29 Count	62 Count	25 Count
1774473976	23 Count	53 Count	20 Count
1774472173	17 Count	41 Count	15 Count
1774468572	5 Count	17 Count	5 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)