APRS Track Direct

My position About ☰

reset

N3EG-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N3EG-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790651457	123	65	30	19	78
1790649657	123	66	31	19	78
1790647857	123	67	31	19	78
1790646058	123	68	31	19	79
1790642457	123	69	32	19	81
1790640657	123	69	32	19	85
1790638857	123	69	32	19	88
1790635256	123	67	31	19	90
1790633456	123	65	30	19	89
1790631657	123	62	30	19	88
1790629856	122	59	30	18	87
1790628057	122	57	29	18	84
1790626257	122	55	28	18	82
1790624457	122	53	28	17	80
1790622657	122	51	27	17	78
1790620857	122	49	26	17	78
1790619056	122	48	26	16	78
1790617257	122	47	26	17	78
1790615456	122	46	26	16	78
1790613656	122	46	26	16	78
1790611857	122	45	25	16	78
1790610056	121	45	25	16	78
1790608256	121	44	25	16	78
1790606456	122	44	25	16	78
1790604656	122	44	25	16	78

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)