APRS Track Direct

My position About ☰

reset

E25XKG-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object E25XKG-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RSSI*	Voltage*
1774131116	-62 dBm	13.58 V
1774129290	-64 dBm	13.58 V
1774127465	-67 dBm	13.58 V
1774125639	-61 dBm	13.58 V
1774123814	-62 dBm	13.58 V
1774121988	-60 dBm	13.58 V
1774120163	-63 dBm	13.54 V
1774118337	-61 dBm	13.58 V
1774116512	-60 dBm	13.56 V
1774114687	-60 dBm	13.56 V
1774112861	-62 dBm	13.54 V
1774111035	-65 dBm	13.47 V
1774109210	-63 dBm	13.49 V
1774107384	-64 dBm	13.49 V
1774105558	-66 dBm	13.54 V
1774103733	-60 dBm	13.56 V
1774101907	-63 dBm	13.56 V
1774100082	-65 dBm	13.49 V
1774098256	-61 dBm	13.47 V
1774096430	-62 dBm	13.47 V
1774094605	-65 dBm	13.49 V
1774092779	-67 dBm	13.54 V
1774090954	-66 dBm	13.45 V
1774089128	-59 dBm	13.49 V
1774087303	-62 dBm	13.45 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)