APRS Track Direct

My position About ☰

reset

SN9GK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SN9GK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790690268	9 Count	671 Count
1790688476	8 Count	565 Count
1790686675	7 Count	486 Count
1790684874	6 Count	417 Count
1790683074	5 Count	356 Count
1790681273	4 Count	293 Count
1790679472	3 Count	217 Count
1790677671	2 Count	166 Count
1790675870	0 Count	113 Count
1790674070	10 Count	1068 Count
1790672269	9 Count	997 Count
1790670468	8 Count	906 Count
1790668667	7 Count	809 Count
1790666876	6 Count	675 Count
1790665075	5 Count	573 Count
1790663274	4 Count	467 Count
1790661473	3 Count	360 Count
1790659673	2 Count	278 Count
1790657872	1 Count	185 Count
1790656071	0 Count	81 Count
1790654270	11 Count	1032 Count
1790652469	10 Count	957 Count
1790650669	9 Count	878 Count
1790648868	8 Count	801 Count
1790647067	7 Count	705 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)