APRS Track Direct

My position About ☰

reset

EB5BZM-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5BZM-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1758212483	17 Count	256 Count
1758210380	16 Count	234 Count
1758208277	15 Count	229 Count
1758206173	14 Count	210 Count
1758204070	13 Count	161 Count
1758201966	10 Count	131 Count
1758199863	9 Count	124 Count
1758197760	8 Count	118 Count
1758195657	6 Count	94 Count
1758193553	5 Count	79 Count
1758191450	4 Count	74 Count
1758189347	3 Count	67 Count
1758187243	2 Count	32 Count
1758185140	1 Count	24 Count
1758183037	0 Count	14 Count
1758180933	218 Count	1020 Count
1758178830	217 Count	977 Count
1758176727	216 Count	942 Count
1758174623	215 Count	893 Count
1758172520	214 Count	879 Count
1758170417	212 Count	879 Count
1758168313	211 Count	879 Count
1758166210	210 Count	879 Count
1758164107	209 Count	879 Count
1758162003	208 Count	879 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)