APRS Track Direct

My position About ☰

reset

SP3KAU-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KAU-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1770106701	53 Count	189 Count	16 Count
1770105860	49 Count	174 Count	15 Count
1770105019	46 Count	157 Count	14 Count
1770104177	43 Count	134 Count	13 Count
1770103337	39 Count	119 Count	12 Count
1770102495	36 Count	98 Count	11 Count
1770101654	31 Count	77 Count	10 Count
1770100813	28 Count	70 Count	9 Count
1770099972	25 Count	62 Count	8 Count
1770099130	21 Count	56 Count	7 Count
1770098289	18 Count	47 Count	6 Count
1770097447	14 Count	40 Count	5 Count
1770096606	10 Count	21 Count	3 Count
1770095765	6 Count	14 Count	2 Count
1770094924	3 Count	8 Count	2 Count
1770094083	312 Count	1002 Count	89 Count
1770093242	308 Count	997 Count	88 Count
1770092311	306 Count	990 Count	87 Count
1770091470	302 Count	984 Count	86 Count
1770090629	299 Count	977 Count	85 Count
1770089788	296 Count	971 Count	84 Count
1770088947	292 Count	964 Count	83 Count
1770088106	289 Count	958 Count	82 Count
1770087265	285 Count	951 Count	81 Count
1770086424	282 Count	945 Count	80 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)