APRS Track Direct

My position About ☰

reset

SP3HUO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3HUO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786728606	871 Count	833 Count	89 Count
1786726805	867 Count	833 Count	89 Count
1786725032	855 Count	833 Count	89 Count
1786723231	849 Count	833 Count	89 Count
1786721430	829 Count	833 Count	89 Count
1786719629	820 Count	833 Count	89 Count
1786717828	815 Count	833 Count	89 Count
1786716027	810 Count	833 Count	89 Count
1786714226	805 Count	833 Count	89 Count
1786712424	791 Count	833 Count	89 Count
1786710622	786 Count	833 Count	89 Count
1786708821	781 Count	833 Count	89 Count
1786707020	767 Count	833 Count	89 Count
1786705219	761 Count	833 Count	89 Count
1786703418	752 Count	833 Count	89 Count
1786701616	747 Count	833 Count	89 Count
1786699815	740 Count	833 Count	89 Count
1786698014	729 Count	833 Count	89 Count
1786696213	712 Count	833 Count	89 Count
1786694412	690 Count	820 Count	76 Count
1786692611	685 Count	820 Count	76 Count
1786690809	680 Count	820 Count	76 Count
1786689008	675 Count	820 Count	76 Count
1786687207	670 Count	820 Count	76 Count
1786685405	646 Count	813 Count	69 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)