APRS Track Direct

My position About ☰

reset

SP2SGL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1774086763	205 Count	251 Count	197 Count
1774084962	199 Count	244 Count	192 Count
1774083162	193 Count	237 Count	187 Count
1774081369	179 Count	219 Count	174 Count
1774079568	146 Count	178 Count	142 Count
1774077767	115 Count	140 Count	112 Count
1774075967	80 Count	101 Count	78 Count
1774074166	51 Count	64 Count	50 Count
1774072365	23 Count	29 Count	23 Count
1774070564	796 Count	1012 Count	694 Count
1774068764	773 Count	983 Count	672 Count
1774066963	750 Count	954 Count	650 Count
1774065162	722 Count	921 Count	623 Count
1774063361	696 Count	890 Count	598 Count
1774061561	670 Count	859 Count	573 Count
1774059769	642 Count	824 Count	546 Count
1774057969	611 Count	784 Count	516 Count
1774056167	582 Count	746 Count	488 Count
1774054366	554 Count	710 Count	461 Count
1774052565	541 Count	693 Count	449 Count
1774050764	531 Count	678 Count	440 Count
1774048964	526 Count	667 Count	436 Count
1774047163	521 Count	655 Count	432 Count
1774045362	514 Count	640 Count	426 Count
1774043561	506 Count	628 Count	419 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)