APRS Track Direct

My position About ☰

reset

KF0X-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KF0X-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786736190	137	95	255	91	69
1786734986	137	95	255	91	72
1786734383	137	95	255	91	72
1786733782	137	95	255	91	72
1786733180	137	95	255	91	72
1786732579	137	95	255	92	70
1786731978	137	95	255	91	70
1786731377	137	95	255	91	70
1786730774	137	95	255	91	70
1786730173	137	95	255	92	70
1786729569	137	95	255	91	69
1786728968	137	95	255	91	70
1786727765	137	95	255	92	70
1786725960	137	95	255	91	70
1786725359	137	95	255	91	69
1786724758	137	95	255	91	69
1786724156	137	95	255	91	70
1786723554	137	95	255	91	70
1786722953	137	95	255	91	70
1786722352	137	95	255	91	70
1786721751	137	95	255	92	70
1786721150	137	95	255	92	70
1786720549	137	95	255	92	70
1786719345	137	94	255	92	70
1786718743	137	94	255	92	70

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)