APRS Track Direct

My position About ☰

reset

VE2SBR-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE2SBR-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790645483	176	141	55	147	255
1790643682	175	138	55	147	255
1790641885	175	148	56	147	255
1790640082	175	136	55	147	255
1790638285	175	134	55	147	255
1790636482	176	142	55	147	255
1790634684	175	136	56	147	255
1790632884	176	193	56	147	255
1790631083	176	141	56	147	255
1790629284	176	160	56	147	255
1790627485	175	190	56	148	255
1790625683	175	191	56	147	255
1790623888	175	167	55	148	255
1790622082	175	185	55	149	255
1790620283	176	141	56	150	255
1790618485	175	164	56	148	255
1790616687	176	167	58	148	255
1790614885	175	151	56	148	255
1790613086	175	172	55	148	255
1790611288	175	192	56	147	255
1790609486	175	169	55	148	255
1790607683	175	190	55	148	255
1790605883	175	152	55	148	255
1790604083	175	146	56	148	255
1790602284	175	173	56	149	255

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)