APRS Track Direct

My position About ☰

reset

DC9DC-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DC9DC-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Volt*	Ampere*
1753676295	4.9 V	158.8 A
1753674495	4.9 V	166.3 A
1753672695	4.9 V	166.3 A
1753670895	4.9 V	166.3 A
1753669095	4.9 V	166.3 A
1753667295	4.9 V	166.3 A
1753665495	5 V	91.3 A
1753663695	5 V	93.8 A
1753661895	5 V	91.3 A
1753660095	5 V	91.3 A
1753658295	5 V	92.5 A
1753654695	5 V	92.5 A
1753652895	5 V	92.5 A
1753651095	5 V	91.3 A
1753649294	5 V	90 A
1753647494	5 V	87.5 A
1753645694	5 V	91.3 A
1753643894	5 V	91.3 A
1753642094	5 V	90 A
1753640294	5 V	92.5 A
1753638494	5 V	92.5 A
1753636694	5 V	91.3 A
1753634894	5 V	88.8 A
1753633094	4.9 V	96.3 A
1753631294	5 V	92.5 A

*Used Equation Coefficients:

Volt: 0, 1, 0

Ampere: 0, 1, 0

Batt: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)