APRS Track Direct

My position About ☰

reset

VE7ROC Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE7ROC. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786722258	148	31	67	41	48
1786720435	145	29	65	41	48
1786718603	134	0	45	41	48
1786716774	134	32	92	41	48
1786714935	130	30	68	41	48
1786713099	129	46	61	41	48
1786711251	128	29	68	41	48
1786709411	128	30	66	41	48
1786707561	128	29	68	41	48
1786705717	128	29	67	41	48
1786703869	129	31	68	41	48
1786702034	128	29	68	41	48
1786700201	129	29	67	41	48
1786698377	129	30	67	41	48
1786696551	129	28	66	41	48
1786694721	129	26	68	41	48
1786692892	129	29	65	41	48
1786691071	131	29	64	65	48
1786689235	131	31	65	41	48
1786687402	131	29	91	41	48
1786685564	132	29	66	41	48
1786683727	133	29	91	41	48
1786681893	133	33	64	41	48
1786680052	134	32	91	41	74
1786678218	135	29	63	41	48

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)