APRS Track Direct

My position About ☰

reset

YO3JAZ-D1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YO3JAZ-D1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value4*	Value5*
1765980457	110	171	81	25
1765980097	110	171	81	25
1765979737	110	171	80	28
1765979377	110	171	81	28
1765979017	110	171	80	25
1765978657	110	171	80	25
1765978297	110	171	81	25
1765977937	110	171	80	28
1765977577	110	171	82	27
1765977217	110	171	81	28
1765976857	110	171	81	25
1765976497	110	171	81	25
1765976137	110	171	79	28
1765975777	110	171	79	27
1765975417	110	171	80	27
1765975057	110	171	79	25
1765974697	110	171	82	25
1765974337	110	171	82	28
1765973977	110	171	81	28
1765973617	110	171	82	27
1765973257	110	171	79	25
1765972897	110	171	81	25
1765972537	110	172	83	25
1765972177	110	172	81	27
1765971817	110	172	81	28

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)