APRS Track Direct

My position About ☰

reset

SP2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1836274120	433 Count	893 Count	419 Count
1762328910	434 Count	651 Count	410 Count
1762327110	407 Count	616 Count	384 Count
1762325309	385 Count	586 Count	363 Count
1762323508	368 Count	560 Count	347 Count
1762321708	348 Count	533 Count	328 Count
1762319907	335 Count	514 Count	316 Count
1762318107	315 Count	488 Count	297 Count
1762316306	297 Count	462 Count	280 Count
1762314505	279 Count	435 Count	263 Count
1762312705	261 Count	404 Count	246 Count
1762310904	246 Count	377 Count	232 Count
1762309104	227 Count	350 Count	214 Count
1762307303	212 Count	327 Count	200 Count
1762305502	195 Count	295 Count	184 Count
1762303702	177 Count	273 Count	167 Count
1762301901	160 Count	251 Count	151 Count
1762300101	148 Count	233 Count	140 Count
1762298300	130 Count	205 Count	123 Count
1762296499	114 Count	171 Count	108 Count
1762294699	98 Count	149 Count	93 Count
1762292898	81 Count	126 Count	77 Count
1762291097	66 Count	105 Count	63 Count
1762289297	47 Count	73 Count	45 Count
1762287496	28 Count	43 Count	27 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)