APRS Track Direct

My position About ☰

reset

KB5SQG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KB5SQG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786729421	156	211	255	212	36
1786729300	155	211	255	212	36
1786729179	155	211	255	212	36
1786729058	155	211	255	212	36
1786728937	155	211	255	212	36
1786728453	155	210	255	213	36
1786728331	155	210	255	213	36
1786728210	155	210	255	213	36
1786728089	155	210	255	213	36
1786727847	155	209	255	213	37
1786727484	155	209	255	214	37
1786727363	155	209	255	214	37
1786727121	155	209	255	215	37
1786726878	155	209	255	216	37
1786726757	154	209	255	216	37
1786726636	155	209	255	217	37
1786726515	154	209	255	217	38
1786726394	154	209	255	218	38
1786726152	154	208	255	219	38
1786726031	155	207	255	220	39
1786725910	155	207	255	221	39
1786725789	155	207	255	222	39
1786725546	155	205	255	224	40
1786725425	155	204	255	226	41
1786725304	154	203	255	227	42

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)