APRS Track Direct

My position About ☰

reset

VE6DWX-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE6DWX-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Vin*	Temp*
1753678904	13.28 Volt	18.5 C
1753674572	13.35 Volt	19.5 C
1753670964	13.58 Volt	20.5 C
1753669164	13.73 Volt	20.5 C
1753667364	13.65 Volt	20 C
1753665564	13.73 Volt	20 C
1753661964	13.8 Volt	21 C
1753660165	13.5 Volt	21.5 C
1753654807	13.73 Volt	23 C
1753653055	13.8 Volt	23 C
1753651165	13.73 Volt	22.5 C
1753650188	13.8 Volt	22.5 C
1753645829	13.73 Volt	22 C
1753636765	13.8 Volt	19.5 C
1753634965	13.73 Volt	19 C
1753629575	13.8 Volt	17 C
1753627934	13.8 Volt	16.5 C
1753624283	14.4 Volt	16 C
1753622366	13.58 Volt	16 C
1753620566	13.2 Volt	16 C
1753618766	13.13 Volt	16 C
1753616966	13.13 Volt	16.5 C
1753615166	13.13 Volt	16.5 C
1753613366	13.13 Volt	17 C
1753611566	13.2 Volt	17.5 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Temp: 0, 0.5, -64

A3: 0, 0, 0

A4: 0, 0, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)