APRS Track Direct

My position About ☰

reset

SR7U-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR7U-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1774099987	804 Count	237 Count	78 Count
1774096385	802 Count	237 Count	78 Count
1774094593	797 Count	237 Count	78 Count
1774092792	796 Count	237 Count	78 Count
1774090992	795 Count	237 Count	78 Count
1774087390	793 Count	237 Count	78 Count
1774085589	792 Count	237 Count	78 Count
1774083788	791 Count	237 Count	78 Count
1774081988	790 Count	237 Count	78 Count
1774080187	789 Count	237 Count	78 Count
1774078386	788 Count	237 Count	78 Count
1774076585	787 Count	237 Count	78 Count
1774074784	786 Count	237 Count	78 Count
1774072992	781 Count	237 Count	78 Count
1774071191	780 Count	237 Count	78 Count
1774069391	779 Count	237 Count	78 Count
1774067590	778 Count	237 Count	78 Count
1774065789	777 Count	237 Count	78 Count
1774063988	776 Count	237 Count	78 Count
1774062187	775 Count	237 Count	78 Count
1774060386	774 Count	237 Count	78 Count
1774058586	773 Count	237 Count	78 Count
1774056785	772 Count	237 Count	78 Count
1774054984	771 Count	237 Count	78 Count
1774053183	770 Count	237 Count	78 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)