APRS Track Direct

My position About ☰

reset

3Z2T-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 3Z2T-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value4*	Value5*
1774086245	69	1001	427	255
1774084445	68	993	427	255
1774082645	67	985	427	255
1774080846	66	977	429	211
1774079046	65	959	427	211
1774077247	64	941	427	210
1774075447	63	928	426	211
1774073647	62	915	425	211
1774071848	61	901	425	210
1774070048	60	887	425	211
1774068248	59	874	425	27
1774066448	58	852	425	16
1774064649	57	839	425	16
1774062850	56	826	425	16
1774061050	55	813	425	16
1774059251	54	800	425	16
1774057452	53	780	425	16
1774055653	52	760	425	16
1774053853	51	746	426	16
1774052054	50	733	426	16
1774050255	49	719	426	16
1774048456	48	705	426	16
1774046657	47	692	427	16
1774044858	46	673	427	16
1774043058	45	656	427	16

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)