APRS Track Direct

My position About ☰

reset

F4IZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4IZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786730132	167 Count	533 Count	141 Count
1786728323	157 Count	517 Count	132 Count
1786726518	150 Count	505 Count	126 Count
1786724713	147 Count	498 Count	124 Count
1786722908	137 Count	486 Count	115 Count
1786721103	134 Count	480 Count	113 Count
1786719298	131 Count	474 Count	111 Count
1786717493	125 Count	468 Count	109 Count
1786715688	122 Count	461 Count	107 Count
1786713883	120 Count	455 Count	106 Count
1786712078	117 Count	448 Count	104 Count
1786710273	114 Count	441 Count	102 Count
1786708468	109 Count	430 Count	98 Count
1786706663	105 Count	410 Count	95 Count
1786704858	102 Count	390 Count	93 Count
1786703053	97 Count	368 Count	89 Count
1786701248	93 Count	345 Count	86 Count
1786699443	87 Count	317 Count	81 Count
1786697638	78 Count	273 Count	73 Count
1786695833	66 Count	225 Count	62 Count
1786694028	57 Count	183 Count	54 Count
1786692223	45 Count	140 Count	43 Count
1786690418	23 Count	91 Count	22 Count
1786688613	9 Count	38 Count	9 Count
1786686808	454 Count	1026 Count	368 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)