APRS Track Direct

My position About ☰

reset

SQ6NLQ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ6NLQ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1766190064	47 Count	980 Count
1766188263	46 Count	968 Count
1766186462	45 Count	957 Count
1766184662	44 Count	939 Count
1766182862	43 Count	863 Count
1766181061	42 Count	760 Count
1766179260	41 Count	724 Count
1766177465	36 Count	700 Count
1766175668	35 Count	675 Count
1766173864	34 Count	647 Count
1766172064	33 Count	620 Count
1766170263	32 Count	591 Count
1766168463	31 Count	555 Count
1766166662	30 Count	523 Count
1766164861	29 Count	496 Count
1766163061	28 Count	467 Count
1766161260	27 Count	376 Count
1766159460	26 Count	354 Count
1766157659	25 Count	329 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)